Upgrading Pse Processing Software In Service - 3Com S7906E Configuration Manual

To do...
Apply the PoE profile to the current
PoE interface
A PoE profile can be applied to multiple PoE interfaces, while a PoE interface can be applied with only
one PoE profile.

Upgrading PSE Processing Software in Service

You can upgrade the PSE processing software in service in either of the following two modes:
refresh mode
This mode enables you to update the PSE processing software without deleting it. Normally, you can
upgrade the PSE processing software in the refresh mode through the command line.
full mode
This mode deletes the PSE processing software and reloads it. If the PSE processing software is
damaged (in this case, you can execute none of PoE commands successfully), you can upgrade the
PSE processing software in full mode to restore the PSE function.
In-service PSE processing software upgrade may be unexpectedly interrupted (for example, an error
results in device reboot). If you fail to upgrade the PSE processing software in full mode after reboot,
you can power off the device and restart it before upgrading it in full mode again. After upgrade, restart
the device manually to make the new PSE processing software take effect.
Follow these steps to upgrade the PSE processing software in service:
To do...
Enter system view
Upgrade the PSE processing
software in service
Use the command...
apply poe-profile { index index |
name profile-name }
Use the command...
system-view
poe update { full | refresh }
filename pse pse-id
1-13
Remarks
Required
Remarks
—
Required