Configuring Pse Power Monitoring; Monitoring Pd; Configuring Poe Interface Through Poe Profile; Configuring Poe Profile - 3Com S7906E Configuration Manual

To do...
Configure a DC output
over-voltage threshold for the
PoE power supply (distributed
IRF device)
The under-voltage threshold should be less than the over-voltage threshold.

Configuring PSE Power Monitoring

When the PSE power exceeds or drops below the specified threshold, the system will send trap
message.
Follow these steps to configure a power alarm threshold for the PSE:
To do...
Enter system view
Configure a power alarm
threshold for the PSE

Monitoring PD

When a PSE starts or ends supplying power to a PD, the system will send a trap message.

Configuring PoE Interface through PoE Profile

You can configure a PoE interface in either of the following two ways:
Using command lines.
Using a PoE profile, and applying the PoE profile to the specified PoE interface(s).
When configuring a single PoE interface, you can use command lines; when you configure PoE
interfaces in batches, you can use a PoE profile.
A PoE profile is a collection of configurations, containing multiple PoE features. On large-scale
networks, you can apply a PoE profile to multiple PoE interfaces, and thus these interfaces have the
same PoE features. If the PoE interface connecting to a PD changes to another one, you just need to
apply the PoE profile applied on the originally connected interface to the currently connected interface
instead of reconfiguring the features defined in the PoE profile one by one, thus simplifying the PoE
configurations.
You can define PoE configurations based on each PD, save the configurations for different PDs into
different PoE profiles, and apply the PoE profiles to the access interfaces of PDs accordingly.

Configuring PoE Profile

Follow these steps to configure a PoE profile:
Use the command...
poe-power output-threshold
chassis chassis-number
upper value
Use the command...
system-view
poe utilization-threshold
utilization-threshold-value pse
pse-id
1-11
Remarks
Optional
The default DC output
over-voltage threshold is 55.00.
Remarks
—
Optional
80% by default.