Configuring The Macaddresselseuserloginsecure Mode - 3Com S7906E Configuration Manual

Configuring the macAddressElseUserLoginSecure Mode

Network requirements
As shown in Figure 1-2,
authenticates the client by the RADIUS server. If the authentication succeeds, the client is authorized to
access the Internet.
Restrict port GigabitEthernet 2/0/1 of the switch as follows:
Allow more than one MAC authenticated user to log on.
For 802.1X users, perform MAC authentication first and then, if MAC authentication fails, 802.1X
authentication. Allow only one 802.1X user to log on.
Set fixed username and password for MAC-based authentication. Set the total number of MAC
authenticated users and 802.1X-authenticated users to 64.
Enable NTK to prevent frames from being sent to unknown MAC addresses.
Configuration procedure
Configurations on the host and RADIUS servers are omitted.
1) Configure the RADIUS protocol
The required RADIUS authentication/accounting configurations and ISP domain configurations are the
same as those in
2) Configure port security
# Enable port security.
<Switch> system-view
[Switch] port-security enable
# Configure a MAC authentication user, setting the user name and password to aaa and 123456
respectively.
[Switch] mac-authentication user-name-format fixed account aaa password simple 123456
# Specify ISP domain sun for MAC authentication.
[Switch] mac-authentication domain sun
[Switch] interface gigabitethernet 2/0/1
# Set the 802.1X authentication method to CHAP. (This configuration is optional. By default, the
authentication method is CHAP for 802.1X.)
[Switch] dot1x authentication-method chap
# Set the maximum number of secure MAC addresses allowed on the port to 64.
[Switch-GigabitEthernet2/0/1] port-security max-mac-count 64
# Set the port security mode to macAddressElseUserLoginSecure.
[Switch-GigabitEthernet2/0/1] port-security port-mode mac-else-userlogin-secure
# Set the NTK mode of the port to ntkonly.
the client is connected to the switch through GigabitEthernet 2/0/1. The switch
Configuring the userLoginWithOUI Mode.
1-18