Displaying And Maintaining Basic Configurations - 3Com S7906E Configuration Manual

If you switch the user privilege level without providing the level argument, the user privilege level will
be switched to level 3.
When the user logs in to the switch through the console port (AUX user interface), if local
authentication mode is applied for user privilege level switch, but the privilege level switch password
of the corresponding level is not configured, no password is required when the user switches to a
privilege level higher than the current one.
Modifying command level
All the commands in a view are defaulted to different levels, as shown in
can modify the command level based on users' needs to make users of a lower level use commands
with a higher level or improve device security.
Follow these steps to modify the command level:
To do...
Enter system view
Configure the command level in
a specified view
You are recommended to use the default command level or modify the command level under the
guidance of professional staff; otherwise, the change of command level may bring inconvenience to
your maintenance and operation, or even potential security problem.

Displaying and Maintaining Basic Configurations

To do...
Display information on system
version
Display information on the
system clock
Display defined command
aliases and the corresponding
commands
Display information on terminal
users
Use the command...
system-view
command-privilege level
level view view command
Use the command...
display version
display clock
display command-alias
display users [ all ]
1-17
Table 1-3. The administrator
Remarks
—
Required
Refer to Table 1-3 for the
default settings.
Remarks
Available in any view