3Com S7906E Configuration Manual page 2503

Configuring a UDP jitter test
Follow these steps to configure a UDP jitter test:
To do...
Enter system view
Enter NQA test group view
Configure the test type as UDP
jitter and enter test type view
Configure the destination
address for a test operation
Configure the destination port
for a test operation
Specify the source port number
for a request
Configure the size of a probe
packet sent
Configure the filler string of a
probe packet sent
Configure the number of
packets sent in a UDP jitter
probe
Configure the interval for
sending packets in a UDP jitter
probe
Configure the time for waiting
for a response in a UDP jitter
test
Configure the source IP
address of a probe request in a
test operation
Use the command...
system-view
nqa entry admin-name
operation-tag
type udp-jitter
destination ip ip-address
destination port
port-number
source port port-number
data-size size
data-fill string
probe packet-number
packet-number
probe packet-interval
packet-interval
probe packet-timeout
packet-timeout
source ip ip-address
1-12
Remarks
—
—
Required
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address must be
consistent with that of the existing
listening service on the NQA
server.
Required
By default, no destination port
number is configured for a test
operation.
The destination port must be
consistent with that of the existing
listening service on the NQA
server.
Optional
By default, no source port number
is specified.
Optional
100 bytes by default.
Optional
By default, the filler string of a
probe packet is the hexadecimal
number 00010203040506070809.
Optional
10 by default.
Optional
20 milliseconds by default.
Optional
3000 milliseconds by default.
Optional
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.