Troubleshooting Ospfv3 Configuration; No Ospfv3 Neighbor Relationship Established - 3Com S7906E Configuration Manual

[SwitchC-Vlan-interface100] ospfv3 1 area 1
[SwitchC-Vlan-interface100] quit
3) Verify the configuration
# After all switches function properly, perform a master/backup switchover on Switch A to trigger a
OSPFv3 GR operation.

Troubleshooting OSPFv3 Configuration

No OSPFv3 Neighbor Relationship Established

Symptom
No OSPF neighbor relationship can be established.
Analysis
If the physical link and lower protocol work well, check OSPF parameters configured on interfaces. The
two neighboring interfaces must have the same parameters, such as the area ID, network segment and
mask and network type. If the network type is broadcast, at least one interface must have a DR priority
higher than 0.
Process steps
1) Display neighbor information using the display ospfv3 peer command.
2) Display OSPFv3 interface information using the display ospfv3 interface command.
3) Ping the neighbor router's IP address to check connectivity.
4) Check OSPF timers. The dead interval on an interface must be at least four times the hello interval.
5) On a broadcast network, at least one interface must have a DR priority higher than 0.
Incorrect Routing Information
Symptom
OSPFv3 cannot find routes to other areas.
Analysis
The backbone area must maintain connectivity to all other areas. If a router connects to more than one
area, at least one area must be connected to the backbone. The backbone cannot be configured as a
Stub area.
In a Stub area, all routers cannot receive external routes, and all interfaces connected to the Stub area
must be associated with the Stub area.
Solution
1) Use the display ospfv3 peer command to display OSPFv3 neighbors.
2) Use the display ospfv3 interface command to display OSPFv3 interface information.
1-28