Activating An Rrpp Domain; Configuring Rrpp Timers - 3Com S7906E Configuration Manual

To do...
Enter system view
Enter RRPP domain view
Specify the current device as a
transit node of the primary ring,
and specify the primary port
and the secondary port
Specify the current device as
the assistant-edge node of the
subring, and specify an edge
port

Activating an RRPP Domain

To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the
RRPP domain on the current device.
Perform this operation on all nodes in the RRPP domain.
Follow these steps to activate an RRPP domain:
To do...
Enter system view
Enable RRPP
Enter RRPP domain view
Enable the specified RRPP ring
On an edge node or assistant-edge node, enable/disable the primary ring and subrings separately as
follows:
Enable the primary ring of an RRPP domain before enabling subrings of the RRPP domain.
Disable the primary ring of an RRPP domain after disabling all subrings of the RRPP domain.

Configuring RRPP Timers

Perform this configuration on the master node of an RRPP domain.
Follow these steps to configure RRPP timers:
To do...
Enter system view
Enter RRPP domain view
Use the command...
system-view
rrpp domain domain-id
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
ring ring-id node-mode assistant-edge
[ edge-port interface-type
interface-number ]
Use the command...
system-view
rrpp enable
rrpp domain domain-id
ring ring-id enable
Use the command...
system-view
rrpp domain domain-id
1-16
Remarks
—
—
Required
Required
Remarks
—
Required
Disabled by default
—
Required
Disabled by default
Remarks
—
—