3Com S7906E Configuration Manual page 1641

<Sysname> system-view
[Sysname] sysname UPE
[UPE] interface loopback 0
[UPE-LoopBack0] ip address 1.1.1.9 32
[UPE-LoopBack0] quit
[UPE] mpls lsr-id 1.1.1.9
[UPE] mpls
[UPE-mpls] quit
[UPE] mpls ldp
[UPE-mpls-ldp] quit
# Configure MPLS basic capability on the interface connected with NPE 1.
[UPE] interface vlan-interface 10
[UPE-Vlan-interface10] ip address 10.1.1.1 24
[UPE-Vlan-interface10] mpls
[UPE-Vlan-interface10] mpls ldp
[UPE-Vlan-interface10] quit
# Configure the remote LDP session.
[UPE] mpls ldp remote-peer 1
[UPE-mpls-remote-1] remote-ip 2.2.2.9
[UPE-mpls-remote-1] quit
# Configure MPLS L2VPN.
[UPE] mpls l2vpn
# Configure the basic attributes of VPLS instance aaa, which uses LDP.
[UPE] vsi aaa static
[UPE-vsi-aaa] pwsignal ldp
[UPE-vsi-aaa-ldp] vsi-id 500
[UPE-vsi-aaa-ldp] peer 2.2.2.9
[UPE-vsi-aaa-ldp] quit
[UPE-vsi-aaa] quit
# Configure interface GigabitEthernet 2/0/1 and bind VPLS instance aaa to VLAN 100.
[UPE] interface gigabitethernet 2/0/1
[UPE-GigabitEthernet2/0/1] service-instance 1000
[UPE-GigabitEthernet2/0/1-srv1000] encapsulation s-vid 100
[UPE-GigabitEthernet2/0/1-srv1000] xconnect vsi aaa
[UPE-GigabitEthernet2/0/1-srv1000] quit
3) Configure NPE 1
# Configure MPLS basic capability.
<Sysname> system-view
[Sysname] sysname NPE1
[NPE1] interface loopback 0
[NPE1-LoopBack0] ip address 2.2.2.9 32
[NPE1-LoopBack0] quit
[NPE1] mpls lsr-id 2.2.2.9
[NPE1] mpls
[NPE1–mpls] quit
1-20