Rsvp-Te Gr Configuration Example - 3Com S7906E Configuration Manual

BackUpBW Type
Route Pinning
Retry Limit
Reopt
Back Up Type
Back Up LSPID
Auto BW
Min BW
Current Collected BW:
Interfaces Protected:
VPN Bind Type
VPN Bind Value
Car Policy
Tunnel Group
Primary Tunnel
Backup Tunnel
Group Status
Oam Status
Perform the display mpls te cspf tedb all command on Switch A to view information about links in
TEDB.
[SwitchA] display mpls te cspf tedb all
Maximum Node Supported: 128
Current Total Node Number: 4
Id MPLS LSR-Id
1 3.3.3.9
2 2.2.2.9
3 4.4.4.9
4 1.1.1.9
7) Create a static route for routing MPLS TE tunnel traffic
[SwitchA] ip route-static 30.1.1.2 24 tunnel 1 preference 1
Perform the display ip routing-table command on Switch A. You can find a static route entry with
interface Tunnel1 as the outgoing interface.

RSVP-TE GR Configuration Example

Network requirements
Switch A, Switch B and Switch C are running IS-IS. All of them are Level-2 devices and support
RSVP hello extension.
Use RSVP-TE to create a TE tunnel from Switch A to Switch C.
Switch A, Switch B and Switch C are RSVP-TE neighbors. With GR capability, each of them can
provide GR helper support when another is GR restarting.
: - BackUpBW
: Disabled
: 5 Retry Interval:
: Disabled Reopt Freq
: None
: -
: Disabled Auto BW Freq :
: - Max BW
-
-
: NONE
: -
: Disabled
: Primary
: -
: -
: -
: Up
IGP Process-Id
ISIS 1
ISIS 1
ISIS 1
ISIS 1
1-50
: -
2 sec
: -
-
: -
Maximum Link Supported: 2048
Current Total Link Number: 6
Area Link-Count
Level-2 2
Level-2 2
Level-2 1
Level-2 1