3Com S7906E Configuration Manual page 1665

Configure MPLS basic capabilities.
Configure MPLS TE basic capabilities.
Configuration Procedure
Follow these steps to create an MPLS TE tunnel over a CR-LSP:
To do...
Enter system view
Enter the interface view of an
MPLS TE tunnel
Configure the tunnel to use
static CR-LSP
Submit the current tunnel
configuration
Exit to system view
Create a static
CR-LSP on
your device
depending on
its location in
the network
The tunnel-name argument specifies the name of the MPLS TE tunnel carried over the static
CR-LSP.
The tunnel-name argument in the static-cr-lsp ingress command is case sensitive. Suppose you
create a tunnel interface with the interface tunnel 2 command. To specify it for the tunnel-name in
the static-cr-lsp ingress command, you must input its name in the form of Tunnel2. Otherwise,
your tunnel establishment attempt will fail. This restriction however does not apply to transit and
egress nodes.
The next hop address cannot be a local public address when configuring the static CR-LSP on the
ingress or a transit node.
Use the command...
system-view
interface tunnel
tunnel-number
mpls te signal-protocol
static
mpls te commit
quit
static-cr-lsp ingress
tunnel-name destination
dest-addr nexthop
At the ingress
next-hop-addr out-label
out-label-value [ bandwidth
[ bc0 | bc1 ] bandwidth-value ]
static-cr-lsp transit
tunnel-name
incoming-interface
interface-type
On the transit
interface-number in-label
node
in-label-value nexthop
next-hop-addr out-label
out-label-value [ bandwidth
[ bc0 | bc1 ] bandwidth-value ]
static-cr-lsp egress
tunnel-name
incoming-interface
At the egress
interface-type
interface-number in-label
in-label-value
1-16
Remarks
––
––
Required
Required
––
Required
Use any of the commands
depending on the location of
your device in the network.