3Com S7906E Configuration Manual page 1692

[SwitchB] static-cr-lsp transit tunnel0 incoming-interface Vlan-interface1 in-label 20
nexthop 3.2.1.2 out-label 30
# Configure Switch C as the egress node of the static CR-LSP.
[SwitchC] static-cr-lsp egress tunnel0 incoming-interface Vlan-interface2 in-label 30
6) Verify the configuration
Perform the display interface tunnel command on Switch A. You can find that the tunnel interface is
up.
[SwitchA] display interface tunnel
Tunnel0 current state: UP
Line protocol current state: UP
Description: Tunnel0 Interface
The Maximum Transmit Unit is 64000
Internet Address is 6.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 3.3.3.3
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
0 packets input,
0 input error
0 packets output,
0 output error
Perform the display mpls te tunnel command on each switch to verify information about the MPLS TE
tunnel.
[SwitchA] display mpls te tunnel
LSP-Id Destination
1.1.1.1:1 3.3.3.3
[SwitchB] display mpls te tunnel
LSP-Id Destination
- -
[SwitchC] display mpls te tunnel
LSP-Id Destination
- -
Perform the display mpls lsp command or the display mpls static-cr-lsp command on each switch to
verify information about the static CR-LSP.
[SwitchA] display mpls lsp
-------------------------------------------------------------------
LSP Information: STATIC CRLSP
-------------------------------------------------------------------
FEC In/Out Label
3.3.3.3/32 NULL/20
[SwitchB] display mpls lsp
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
0 bytes
0 bytes
In/Out-If
-/Vlan1
In/Out-If
Vlan1/Vlan2
In/Out-If
Vlan2/-
In/Out IF
-/Vlan1
1-43
0/100/0
0/500/0
0/75/0
Name
Tunnel0
Name
Tunnel0
Name
Tunnel0
Vrf Name