Configuring The Collaboration Function - 3Com S7906E Configuration Manual

To do...
Configure the destination
address for a test operation
Configure the source IP
address of a probe request in a
test operation
Configure common optional
parameters

Configuring the Collaboration Function

Collaboration is implemented by establishing collaboration entries to monitor the detection results of the
current test group. If the number of consecutive probe failures reaches the threshold, the configured
action is triggered.
Follow these steps to configure the collaboration function:
To do...
Enter system view
Enter NQA test group view
Enter test type view of the test
group
Create a collaboration entry
Exit to system view
Create a track entry and associate
it with the specified collaboration
entry of the NQA test group
You cannot modify the content of a reaction entry using the reaction command after the
collaboration entry is created.
The collaboration function is not supported in a UDP jitter or voice test.
Use the command...
destination ip ip-address
source ip ip-address
Refer to Configuring Optional
Parameters Common to an
NQA Test Group
Use the command...
system-view
nqa entry admin-name
operation-tag
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | snmp | tcp |
udp-echo }
reaction item-num
checked-element probe-fail
threshold-type consecutive
occurrences [ action-type
{ none | trigger-only } ]
quit
track entry-number nqa entry
admin-name operation-tag
reaction item-num
1-19
Remarks
Required
By default, no destination IP
address is configured for a test
operation.
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Optional
Remarks
—
—
The collaboration function is
not supported in UDP jitter
and voice tests.
Required
Not created by default.
—
Required
Not created by default.