Applying Poe Profile - 3Com S7906E Configuration Manual

To do...
Enter system view
Create a PoE profile, and enter
PoE profile view
Enable PoE for the PoE
interface
Configure the maximum power
for the PoE interface
Configure PoE power supply
mode for the PoE interface
Configure power supply priority
for the PoE interface
If a PoE profile is applied, it cannot be deleted or modified before you cancel its application.
The poe max-power max-power and poe priority { critical | high | low } commands must be
configured in only one way, that is, either through command lines or through PoE profile.
A PoE parameter on a PoE interface must be configured, modified and deleted in only one way. If a
parameter configured in a way (for example, through command lines) is then configured in the other
way (for example, through PoE profile), the latter configuration fails and the original one is still
effective. To make the latter configuration effective, you must cancel the original one first.

Applying PoE Profile

You can apply a PoE profile in either of the two views: system view and interface view. If you perform
application to a PoE interface in both views, the latter application takes effect. To apply a PoE profile to
multiple PoE interfaces, the system view is more efficient.
Follow these steps to apply the PoE profile in system view:
To do...
Enter system view
Apply the PoE profile to one or
multiple PoE interfaces
Follow these steps to apply the PoE profile in interface view:
To do...
Enter system view
Enter PoE interface view
Use the command...
system-view
poe-profile profile-name [ index ]
poe enable
poe max-power max-power
poe mode signal
poe priority { critical | high | low }
Use the command...
system-view
apply poe-profile { index index |
name profile-name } interface
interface-range
Use the command...
system-view
interface interface-type
interface-number
1-12
Remarks
—
Required
Required
Disabled by default.
Optional
15400 milliwatts by
default.
Optional
signal (power over
signal cables) by
default.
Optional
low by default.
Remarks
—
Required
Remarks
—
—