3Com S7906E Configuration Manual page 1694

Figure 1-7 Set up MPLS TE tunnels using RSVP-TE
Loop0
Vlan-int1
Switch A
Loop0
Vlan-int1
Switch B
Device Interface
Switch A Loop0
Vlan-int1
Switch B Loop0
Vlan-int1
Vlan-int2
Configuration procedure
1) Assign IP addresses and masks to interfaces (see
Omitted
2) Enable IS-IS to advertise host routes with LSR IDs as destinations
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis 1
[SwitchA-isis-1] network-entity 00.0005.0000.0000.0001.00
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] isis enable 1
[SwitchA-Vlan-interface1] isis circuit-level level-2
[SwitchA-Vlan-interface1] quit
[SwitchA] interface loopback 0
[SwitchA-LoopBack1] isis enable 1
[SwitchA-LoopBack1] isis circuit-level level-2
[SwitchA-LoopBack1] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] isis 1
[SwitchB-isis-1] network-entity 00.0005.0000.0000.0002.00
[SwitchB-isis-1] quit
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] isis enable 1
[SwitchB-Vlan-interface1] isis circuit-level level-2
[SwitchB-Vlan-interface1] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] isis enable 1
Loop0
Vlan-int2
Vlan-int2
Switch C
IP address
1.1.1.9/32
10.1.1.1/24
2.2.2.9/32
10.1.1.2/24
20.1.1.1/24
1-45
Loop0
Vlan-int3
Switch D
Vlan-int3
Device Interface
Switch D Loop0
Vlan-int3
Switch C Loop0
Vlan-int3
Vlan-int2
Figure 1-7)
IP address
4.4.4.9/32
30.1.1.2/24
3.3.3.9/32
30.1.1.1/24
20.1.1.2/24