Table of Contents
Advertisement
5.6.7
Setting BUS Eventpoints
On the [BUS Event] sheet, the settings for BUS Eventpoints are displayed and modified.
Using six event detection channels sets six eventpoints.
Notes: 1. When the trace unit is not connected to the emulator, this function is not supported.
2. When the debugging function of the trace unit is set again, the number of event
detection channels is changed. For details, refer to section 5.1.4, [Bus Board] Page.
Items that can be displayed in the sheet are listed below.
[Type]
External bus event channel number and type
Normal: Standard event channel
Delay: Event channel that delay conditions can be set
Reset: Event channel that can be set as the reset point of the external bus
sequential event
[State]
Whether the eventpoint is enabled or disabled
Enable: Valid
Disable: Invalid
[Condition] A condition that satisfies an eventpoint. The displayed contents differ depending on
the channel.
[Action]
Operation of the emulator when an eventpoint condition is satisfied. The displayed
contents differ depending on the channel.
Figure 5.42 [Event] Window ([BUS Event] Sheet)
199
Advertisement
Table of Contents
