Table of Contents
Advertisement
In this dialog box, specify a range to be shown in the [Code Coverage] window.
[New Window]:
[Start address]:
[End address]:
[File]:
[Open a recent coverage file]:
[Browse to another coverage file]: Allows specification of a file that is not included in the list.
Clicking the [OK] button in this dialog box opens the [Code Coverage] window. The display
format differs depending on whether the address range or source file is specified.
Note: In one [Coverage window], up to 2-Mbyte address ranges can be opened. To check the
whole measurement range, use multiple windows to show the addresses separately.
280
Specifies a new coverage range.
Enter the start address of coverage information to be
displayed (in hexadecimal when the prefix is
omitted).
Enter the end address of coverage information to be
displayed (in hexadecimal when the prefix is
omitted).
Specifies a source file that has ".C" or ".CPP" as its file type
name from the current project. This allows a function included
in the specified file to be set as the coverage range. ".C" will
be automatically specified if the file type name is omitted.
Files with a type name other than ".C" or ".CPP" cannot be
specified here. A placeholder or the [Browse...] button can be
used.
Lists a maximum of four files that were saved most recently.
Select one from the list.
Advertisement
Table of Contents
