Table of Contents
Advertisement
5.1.8
Changing the Memory Map Setting
Clicking the [Edit...] button on the [Memory Mapping] dialog box after selecting the information
on the memory map setting you want to change opens the [Edit Memory Mapping] dialog box.
This dialog box also opens when the [Add...] button is clicked on the [Memory Mapping] dialog
box.
Use this dialog box to change the address range and attributes of a memory map.
[From]:
Enter the start address of the map range.
[Setting]:
Enter the memory map setting.
The choices given are listed below. Since these items differ depending on the
product, refer to the online help.
•
•
•
Note: The unit for mapping the memory is fixed to 4 Mbytes.
Figure 5.9 [Edit Memory Mapping] Dialog Box
EMULATION AREA – 16 bit: The data bus width is 16 bits.
EMULATION AREA – 16 bit Read-Only:
This area is write-protected and the data bus width is 16 bits.
USER AREA: This area is specified as the user area.
147
Advertisement
Table of Contents
