Table of Contents
Advertisement
4. Set the configuration file name. The configuration file saves the state of High-performance
Embedded Workshop except for the emulator.
This is the end of the emulator setting.
Exit the Project Generator according to the instructions on the screen. The High-performance
Embedded Workshop is activated.
5. After the High-performance Embedded Workshop has been activated, connect the emulator.
However, it is not needed to connect the emulator immediately after the High-performance
Embedded Workshop has been activated.
To connect the emulator, use one of the methods (a) and (b) below. For operation during
connection, refer to section 4.1, System Check.
Figure 4.24 [New Project – Step 8] Dialog Box
111
Advertisement
Table of Contents
