Table of Contents
Advertisement
[Data]:
[Don't care]:
[Load/Store]:
[Load]:
[Store]:
[Value]:
[Byte]:
[Word]:
[32 bit]:
[64 bit]:
[Outside]:
Notes: 1. This page is only displayed when [SystemBus trace data] is specified on the [General]
page.
2. The address range can only be specified for AUD event channels Ch1 and Ch2.
3. The mask address can be input for [Start] when the single address is specified.
4. The mask address cannot be input for [Start] and [End] when the address range is
specified.
5. For the load cycle ([Load]), information on the data of the system bus is not output
from the AUD pin. The data condition can be set only for the store cycle.
192
Sets the data condition.
Sets no data condition.
Sets the load or store cycle as the condition (not supported).
Sets the load cycle as the condition (not supported).
Sets the store cycle as the condition.
Sets the data bus value (mask data can be input).
Sets the byte access as the condition.
Sets the word access as the condition.
Sets the 32-bit access as the condition.
Sets the 64-bit access as the condition.
Sets other value than that has been set for [Value] as the condition.
Advertisement
Table of Contents
