Table of Contents
Advertisement
Notes: 1. If the emulator is not initiated, the following dialog boxes shown in figures 4.11
through 4.15 will be displayed.
(a) If the following dialog box is displayed and the method 12 above is unavailable, the
power of the user system may not be input or the RESET signal may not be input to
the device. Check the input circuits for the power of the user system and the reset pin.
(b) If the following dialog box is displayed, the user system may be turned off or the H-
UDI port connector may not be correctly connected. Check that the user system is
turned on and the H-UDI port connector is connected.
Figure 4.11 [Can not find /RESET signal] Dialog Box
Figure 4.12 [Check the connection] Dialog Box
101
Advertisement
Table of Contents
