Table of Contents
Advertisement
(c) Setting the trace acquisition condition
The following is an example of setting the address condition.
For setting other trace conditions, refer to section 5.6, Using the Eventpoints.
Select and double-click [Ch3 (Normal)] on the [BUS Event] sheet of the [Event] window. The
[Ch3 (Normal)] dialog box will appear.
Figure 6.57 [Ch3 (Normal)] Dialog Box ([Address] Page)
• Select [Range].
• Input H'1000 and H'2000 into [Start] and [End], respectively.
• Select [Trace get] in the [Action] page and click the [OK] button.
• The trace information when external memory H'1000 to H'2000 has been accessed is acquired.
354
Advertisement
Table of Contents
