Connecting The Emulator To The Host Machine - Renesas SH-4A User Manual

Be sure to use the AC adapter dedicated for E200F.
Failure to do so will result in a FIRE HAZARD and will damage
the user system or the emulator product.

2.5 Connecting the Emulator to the Host Machine

This section describes how to connect the emulator to the host machine. For the position of each
connector of the emulator, refer to section 1.2, Emulator Hardware Configuration.
Notes: 1. When [Add New Hardware Wizard] is displayed, select the [Search for the best driver
for your device. (Recommended)] radio button and then the [Specify a location] check
box to select the path to be searched for drivers. The location must be specified as
<Drive>:\DRIVERS. (<Drive> is the CD drive letter.)
2. Be sure to install the software for the emulator before putting the emulator in place.
Always switch OFF the emulator product and the user
system before connecting or disconnecting any CABLES
except for the USB interface cable. Failure to do so will result
in a FIRE HAZARD and will damage the user system and the
emulator product or will result in PERSONAL INJURY.
The USER PROGRAM will be LOST.
70
WARNING
WARNING