Table of Contents
Advertisement
1.3.9 Memory Access Functions
The emulator has the following memory access functions.
(1) Memory read/write function
[Memory] window: The memory contents are displayed in the window. Only the amount
me command:
(2) User program downloading function
A load module registered in the workspace can be downloaded. Such module can be selected
from [Download Module] in the [Debug] menu. Downloading is also possible by a popup menu
that is opened by right-clicking on the mouse at the load module in the workspace. The user
program is downloaded to the RAM or flash memory.
When downloading to the flash memory, select [Emulator] from the [Options] menu, open the
[Configuration] window, and perform required settings on the [Loading flash memory] page.
This function also downloads information required for source-level debugging such as debugging
information.
(3) Memory data uploading function
The specified amount of memory from the specified address can be saved in a file.
(4) Memory data downloading function
The memory contents saved in a file can be downloaded. Select [Load] from the popup menu in
the [Memory] window.
(5) Displaying the variable contents
The variable contents specified in the user program are displayed.
52
specified when the [Memory] window is opened can be read. Since there is
no cache in the emulator, read cycles are always generated. If the memory is
written in the [Memory] window, read cycles in the range displayed in the
[Memory] window will occur for updating the window. When the [Memory]
window is not to be updated, change the setting in [Lock Refresh] from the
popup menu.
A command line function that reads or writes the specified amount of
memory at the specified address.
Advertisement
Table of Contents
