Table of Contents
Advertisement
(7) [Sequential BUS Event] dialog box
The sequential bus event occurs when all the BUS Eventpoint conditions are satisfied in the
specified order.
Bus event channel Ch1 can be specified as the reset point. When the reset point is passed, the
satisfied eventpoint condition is disabled and checking the first eventpoint condition is started.
[Don't care]:
[Channel select]:
Figure 5.49 [Sequential BUS Event] Dialog Box
Sets no Sequential BUS Event condition.
Specifies the order that the Sequential BUS Event is satisfied.
[Channel 3 -> 2]:
After conditions have been matched in the order of bus event channel 3
-> 2, a Sequential BUS Event occurs.
[Channel 4 -> 3 -> 2]:
After conditions have been matched in the order of bus event channel 4
-> 3 -> 2, a Sequential BUS Event occurs.
[Channel 5 -> 4 -> 3 -> 2]:
After conditions have been matched in the order of bus event channel 5
-> 4 -> 3 -> 2, a Sequential BUS Event occurs.
207
Advertisement
Table of Contents
