Table of Contents
Advertisement
• Select the [2 Channel Sequential] radio button and [Channel 2 -> 1], and click the [OK] button.
When the setting is completed, the [Event] window will be as shown in figure 6.41.
Figure 6.41 [Onchip Event] Sheet
Note: The items that can be displayed in this dialog box differ according to the product. For the
items that can be displayed, refer to the online help.
• Set the program counter and stack pointer values (PC = H'00000800 and R15 = H'00010000)
that were set in section 6.8, Setting Registers, in the [Register] window. Click the [Go] button.
• If program execution is failed, reset the device and execute again the procedures above.
332
Advertisement
Table of Contents
