Table of Contents
Advertisement
(7) [Delay] page
Sets the delay cycle from the event detection to the AUD trace stop.
[Don't care]:
[Delay]:
[Clock]:
Notes: 1. This page is only displayed when AUD event channel Ch2 is selected and [Trace stop]
is specified on the [Action] page.
2. When PPC information is output by the AUD trace, two sets of AUD trace information
are specified as one cycle.
194
Figure 5.39 [Chx (Delay)] Dialog Box ([Delay] Page)
Sets no delay condition.
Sets the delay cycle counts; D'0 to D'262143 is available.
Sets a cycle for delay measurement.
[100ns]:
[number of trace information]: Specifies a set of AUD trace information
Specifies 100 ns as one cycle.
as one cycle.
Advertisement
Table of Contents
