Table of Contents
Advertisement
• Operands
• Source lines
Notes: 1. The AUD trace function is not supported for all products. For details on the
specifications of each product, refer to the online help.
2. The types of trace information that can be acquired by an AUD trace function differ
according to the product. For details on the specifications of each product or the
number of acquired branches, refer to the online help.
3. When multiple loops are performed to reduce the number of AUD trace displays, only
the IP counts up according to the product.
• Memory Output Trace Function
This function is used to write the trace result to the specified memory range. The data is read
from the memory range written in the [Trace] window and the result is then displayed. This is
large-capacity trace function that is useful when the AUD pin of the device is not connected to
the emulator.
Note: Some products do not support the memory output trace function. For details on the
specifications of each product, refer to the online help.
• External Bus Trace Function
This is a large-capacity trace function that is valid when the external bus pin of the MPU is
connected to the emulator.
The external bus trace function can acquire the information of a maximum of 262,144 cycles
per bus cycle.
The following information can be acquired:
• External bus address values
• External bus data values
• Interrupt signal states
• Time stamp values
• Mnemonics
• Operands
Note: The types of trace information that can be acquired differ according to the product. For
details on the specifications, refer to the online help.
336
Advertisement
Table of Contents
