Renesas SH-4A User Manual page 212

[Data]:
[Don't care]:
[Read/Write]: Sets the read or write cycle as the condition.
[Read]:
[Write]:
[Value]:
[Byte]:
[Word]:
[32 bit]:
[Outside]:
Notes: 1. This page is only displayed when [Window trace data] is specified on the [General]
page.
2. The address range can only be specified for AUD event channels Ch1 and Ch2.
3. The mask address can be input for [Start] when the single address is specified.
4. The mask address cannot be input for [Start] and [End] when the address range is
specified.
188
Sets the data condition.
Sets no data condition.
Sets the read cycle as the condition.
Sets the write cycle as the condition.
Sets the data bus value (mask data can be input).
Sets the byte access as the condition.
Sets the word access as the condition.
Sets the 32-bit access as the condition.
Sets other value than that has been set for [Value] as the condition.