Table of Contents
Advertisement
[Data]:
[Don't care]:
[Value]:
[Outside]:
Notes: 1. This page is only displayed when [Software trace data] is specified on the [General]
page.
2. The address range can only be specified for AUD event channels Ch1 and Ch2.
3. The mask address can be input for [Start] when the single address is specified.
4. The mask address cannot be input for [Start] and [End] when the address range is
specified.
190
Sets the data condition.
Sets no data condition.
Sets the data bus value (mask data can be input).
Sets other value than that has been set for [Value] as the condition.
Advertisement
Table of Contents
