Table of Contents
Advertisement
[Sequential reset]: Selects whether or not bus event channel Ch1 is used as the reset point.
[Action]:
Note: When the Sequential BUS Event condition is set and the eventpoint condition is edited
with the bus event channel that has been selected for [Channel select], the [Action] page
cannot be modified. To modify the settings of the [Action] page, cancel the Sequential
BUS Event condition. When a sequential event is specified, no condition will be satisfied
on channels other than those selected for this event.
208
[Channel 6 -> 5 -> 4 -> 3 -> 2]:
After conditions have been matched in the order of bus event channel 6
-> 5 -> 4 -> 3 -> 2, a Sequential BUS Event occurs.
[Disable]: Not used as the reset point.
[Enable]: Used as the reset point.
Specifies the operation after the Sequential BUS Event has been
detected.
[Break]: Breaks after the Sequential BUS Event has been detected.
[Trace stop]: Stops external bus trace after the Sequential BUS Event
has been detected.
Advertisement
Table of Contents
