Table of Contents
Advertisement
Breaks when the specified event has been detected by other event detection functions.
This function is available when the operation after detecting an event is set as 'break' in the
[Other Event] sheet of the [Event] window.
(6) Trace break function
Breaks when the AUD trace buffer and external bus trace buffer in the emulator become full.
This function can be set in the [Internal/AUD/Usermemory acquisition] dialog box and the
[BUS acquisition] dialog box.
(7) Forced break function
Forcibly breaks the user program.
1.3.5 Probe Function
Six external probes can be placed on the emulator.
(1) Four input probes
Monitor input signals, break the user program, and start or end AUD tracing by satisfying the
specified condition. This can be set on the [Other Event] sheet of the [Event] window.
(2) One event output probe
Outputs the event signal when the AUD event is detected. This can be set on the [Action] page
of the dialog box for setting the AUD event.
(3) One GND
A probe for connecting the ground.
1.3.6 Peripheral I/O Analyzer Functions
When the pin signals of peripheral I/Os are connected to the analyzer cable, the emulator sets a
break and starts or ends tracing the pin signals with the specified condition by analyzing the
protocols of peripheral IPs.
Note: The analyzer functions to be supported differ depending on the product. For details on the
specifications of each product, refer to the additional document, Supplementary
Information on Using the SHxxxx, or the online help.
36
Advertisement
Table of Contents
