Table of Contents
Advertisement
[Loading flash memory]
[Erasing flash memory]
[File name]
[Bus width of flash memory]
[Flash memory erasing time]
[Entry point]
144
Sets Enable for flash memory downloading. At Enable, when
the flash memory is downloaded on the High-performance
Embedded Workshop, the write module is always called.
[Disable]: Not download to the flash memory
[Enable]: Download to the flash memory
Sets Enable for erasing before the flash memory is written. At
Enable, the erase module is called before calling the write
module.
[Disable]: Not erase the flash memory
[Enable]: Erase the flash memory
Sets the write/erase module name. The file that has been set is
loaded to the RAM area before loading to the flash memory.
Sets the bus width of the flash memory.
Sets the TIMEOUT value at flash memory erasing. Increase
the value if erasing requires much time although the default
time is three minutes. The values that can be set are as follows:
D'0 (minimum) and D'65535 (maximum). Only positive
integers can be input.
Sets the calling destination address of the write/erase module.
(It must be RAM address.)
[All erasing module address]: Enters the calling destination
[Writing module address]: Enters the calling destination
[Access size]:
address of the erase module.
address of the write module.
Selects the access size of the
RAM area that is used for loading
the write/erase module.
Advertisement
Table of Contents
