Using The Remote Control; Setting Up The Viewstation Sp - Polycom ViewStation SP128 User Manual

Chapter 1

Using the Remote Control

Setting Up the ViewStation SP

© Polycom, Inc.
The remote control packaged with the ViewStation SP is an integral
part of the unit. Use the remote to highlight and select icons on the
television monitor, enter alphanumeric characters in text fields,
configure the address book, move the camera, adjust the volume,
and place video calls. Remote control functionality is described on
the ViewStation SP QuickStart card.
Setting up the ViewStation SP is easy. First, locate the QuickStart
card in the ViewStation SP box.
The cable connectors are color-coordinated with the corresponding
connectors on the back of the ViewStation SP. To connect the
ViewStation SP, use the QuickStart Card as a guide and follow the
steps below.
1. Place the ViewStation SP unit on top of the television monitor as
shown in Figure 1-1. Ensure that the front lip of the ViewStation
SP unit hangs over the edge of the television monitor.
Note Verify that the top surface area on the monitor is adequate
to support the ViewStation SP. The surface area of the
television monitor should provide enough support to prevent
the ViewStation SP from sliding behind the monitor.
Figure 1-1. Placing the ViewStation SP
3
Getting Started
ViewStation SP User Guide