Bsc Interactive Port Subscriber Parameters - Cabletron Systems Netlink FRX4000 User Manual
Frame relay access products
Hide thumbs
Also See for Netlink FRX4000:
- Maintenance manual (60 pages) ,
- Installation and setup manual (8 pages) ,
- User manual (420 pages)
Table of Contents
Advertisement
Parameter
Sq
Local Sub
Remote Sub
Atcl
Rtytm
Rty#
Conn ID
Explanations of Port Parameters
Port Type
defines the protocol the port will support. Selecting this parameter will display a list
of valid protocols. An FRX4000 port can be configured as any WAN protocol loaded
in the device. An FRX6000 port can be configured as any WAN protocol configured
on this port's RLP. (Protocol configuration is described in
Physical Port Interface
must be configured as follows. For reference, port locations are shown on
(FRX4000) and
FRX4000 port 0 is always
FRX4000 port 1 must be
FRX4000 ports 2 and 3 are determined by the attached cables: RS-232, V.35,
RS-449, or X.21.
FRX4000 ports 4–7 are determined by the expansion Line Interface Card (LIC)
and attached I/O cables. Line Processor Configuration identifies the LIC, and
only the valid interfaces will be displayed on the Port screen. Possible interfaces
are RS-232, V.35, RS-449, and X.21. (RS-449 and X.21 interfaces require an
RS-422 LIC, which is available by special order.)
FRX6000 ports 0–7 on each RLP are determined by the Line Interface Card(s)
and attached I/O cables. Line Processor Configuration identifies the LIC, and
only the valid interfaces will be displayed on the Port screen. Possible interfaces
are RS-232, V.35, RS-449, and X.21
require an RS-422 LIC.)
Blocked Port Flag
will cause the port to be enabled (
in that state until this parameter is changed or an on-line enable (
Main Menu) or disable (
Table 10-2 BSC Interactive Port Subscriber Parameters
(Sequence)
(Autocall)
(Retry Timer) (sec)
(Retry Number)
If the TPAD is connecting to a logical X.25 port in the FRX4000/6000,
1
to
Y
.
page 6-2
(FRX6000).
[B], [B], [A]
Valid Values
1–16
0–15 characters
0–15 characters
(used only on TPAD)
Y/N
15–255
0–255
00–ff
.
RS-232
if the port is being configured as BSC.
RS-232
. (RS-449, RS-530, and X.21 i
) or disabled (
) at node IPL. The port will remain
N
Y
from the Main Menu) is performed.
Default Value
none
none
none
1
N
60
0
(indefinite)
none
must be set
Atcl
Chapter
5.)
page 6-1
nterfaces
from the
[B], [B], [C]
Advertisement
Table of Contents
