Configuring Subscriber Ids; Typical Svc Subscriber Screen - Cabletron Systems Netlink FRX4000 User Manual

Atcl
Rtytm
Rty#
Conn ID

Configuring Subscriber IDs

(Autocall) causes a BSC TPAD to automatically call its HPAD when the controller
(identified by Link Address) becomes active. This parameter has no function if the
port is an HPAD.
is the Retry Timer, which determines the time between autocall retries.
is the maximum number of times an autocall will be sent.
is an internal connection identifier that will link the BSC port with a device configured
in the BSC Devices file (described on page 10-11).
This operation configures the called and calling addresses that will be used in X.25
call setup if BSCI is being transported over a logical X.25 port. To complete the con-
nection, the software must recognize where the call is coming from (calling address)
and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press
Routing Paths Menu (or
To add or change a Subscriber ID, press
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on page 8-22.)
SVC Subscriber Maintenance
* Subscriber ID
A Subscriber Name
B Routing Algorithm
C Systematic Redirection
D Redirect on Busy
E Redirect on Out of Order
F Connection Priority
G Routing Paths
H Redirection Addresses
Option:
Figure 10-3 Typical SVC Subscriber Screen
from the Main Menu).
[A], [D], [A]
at the Connections and Routing Paths
[B]
0100012345
sub1
0, Round Robin
N
N
N
0
at the Connections and
[A]
Node Name=nodexyz
from Main Menu
[A],[D],[B]