Serial Ports On An Frx4000; Protocol Configuration Menu For Frx4000 - Cabletron Systems Netlink FRX4000 User Manual

5-2
For reference, the following figure shows the ports on an FRX4000.
Optional
LAN
CSU/DSU
Ports 4–7 are on optional expansion module
Port
Port
WAN 4
WAN 0
Figure 5-1 Serial Ports on an FRX4000
The above example shows a V.35, RS-232, or RS-422 expansion card. A
T1 or E1 expansion card will contain Port 4 only.
To display a table of memory usage, press
information, in conjuction with information in the release notes, can help in planning
the number of protocols to run.
To configure a protocol, press
RLP Configuration
* RLP: 0 * Status: Installed
* RLP Type: RLP
* Line Interface Card 1: UNIVERSAL
* Line Interface Card 2: T1-DSX1
F Protocol 1:
G Protocol 2:
H Protocol 3:
I Protocol 4:
J Protocol 5:
K Protocol 6:
L Protocol 7:
M Protocol 8:
N Protocol 9:
Option:
Figure 5-2 Protocol Configuration Menu for FRX4000
, ,
RLP Status
above.
Line Interface Card 2
The line
Configure T1/E1 LIC 1
Card is or
T1
WAN 5 WAN 6
WAN 1 WAN 2
[C]
at the RLP Configuration Menu.
[B]
* Memory Configuration: 8 Meg
D Configure T1/E1 LIC2
Configured Loaded
FR FR
IP IP
Async Async
SDLC SDLC
BSCI BSCI
None
None
None
None
[A],[B],[B]
, and
RLP Type Line Interface Card 1
will be read from the installed card (if present).
(or
2
.
E1
Console
Port
WAN 7
WAN 3
at the RLP Configuration Menu. This
Node Name=nodexyz
from Main Menu
will always be as shown
) is displayed if either Line Interface
FRX4000/FRX6000 4.0 User Guide, Rev 01