Configuring Default Node-Wide Bridging Parameters; Bridge Node Defaults Configuration Screen - Cabletron Systems Netlink FRX4000 User Manual

Configuring Default Node-Wide Bridging Parameters

Configuring Bridging
If one or more Bridge ports (interfaces) will be established in the local node, certain
parameters must be configured to define bridge operation. Press
IP/LLC2/BRIDGE/IPX Default Parameters Menu (or
Menu). When prompted, enter:
– if also configuring LLC2 or Bridging in the node, enter a value
Virtual LAN ID
of (hex). Otherwise, press
0–fff
LAN IDs can also be configured in LLC2 Interface/Bridge
Port records (later in this chapter). Each LAN ID must be
unique within the network on which this node will operate.
Any remaining requested information, referring to
Configure Bridge/LLC2 Node Defaults
A Virtual LAN ID
B Bridge Enabled
C Bridge Hello Time
D Bridge Max Age
E Bridge Forward Delay
F Bridge Aging Timer (seconds)
G Bridge Priority
H Max Size Bridge Forwarding Table
I IP Bridging Enabled
J IPX Bridging Enabled
K SRB ID
L Default Ethernet Frame Type
Option::
Figure 15-1 Bridge Node Defaults Configuration Screen
[A], [A], [E], [B]
(accepting the default of
[Enter]
Table
Node Name=node_xyz
000
N
2
20
15
300
0
65535
N
N
0
Type II
[A],[A],[E],[B]
at the Configure
[B]
from the Main
).
000
15-1.
from Main Menu
15-3