Remote Software Update - Cabletron Systems Netlink FRX4000 User Manual

Remote Software Update

On-line Operations
This operation allows an operator to send a complete software update from one
FRX4000 to another, from one FRX6000 to another, or between an FRX6000 and a
FRM. The file UPDATE.TXT contains a list of the files that will be transferred.
Before an update is performed, make sure a
Node Defaults.
Packet switching is reduced when multiple file transfers occur, because of
the data I/O. However, there should be no other side effects.
1. Press at the On-Line Node Operations menu (or
[C]
Menu).
2. When prompted, enter the
node you are updating.
3. If updating an FRX4000, go to step 6.
If updating an FRX6000, you will be asked:
If the remote node (FRX6000 only) has a directly attached VGA
Async terminal?
or monochrome monitor, or if you know that one will be used for configuration
operations, press
[N]
4. You will be asked:
to accept the default of
[Enter]
of LAN cards and go to step 5
5. You will be asked to specify the type of LAN card
and .) Enter the appropriate number from the choices:
0 1
3 – SMC EtherCard Plus Elite16
4 – IBM Token Ring Card
5 – SMC Token Ring Card
If only one LAN card is installed, go to step 6. If two are installed, repeat step 5
for the second card, then go to step 6.
6. When asked:
Initiate File Transfer?
7. If asked:
Are you sure you want to do a remote software update?
The "old" and new release numbers of the database will be displayed, along with the
new release number of the FRX4000/6000 operating software.
The transfer process is as follows, and is repeated for each file, except where noted in
step 1. To assure that there is enough disk space for a multiple file transfer, the largest
file will be sent first. It will be transferred only if there is enough disk space for the
new file and the file it is replacing. Once the transfer is complete, the old file will be
deleted, providing enough disk space to accommodate the next file.
1. The originating node will send a message that includes a request for the remote
node's release number, the file name and size. (The request for release number
will be sent only with the first file name.) If the release numbers of the sending
and receiving nodes are incompatible, the transfer will not occur, and an error
message will be displayed. If this happens, contact your service representative.
and
File Transfer ID
. Otherwise, press .
[Y]
How many LAN cards have you installed (0-2)?
, then go to step 6. Otherwise, enter the number
0
.
, press
[Y]
is specified in
File Transfer ID
from the Main
[B], [A], [C]
(password) of the
File Transfer Pwd
Will the remote node be using an
If none, press
. (LAN cards are numbered
0
.
, press .
[Y]
18-5