Cabletron Systems Netlink FRX4000 User Manual page 353

System Events
379.
LIC "n" Config Mismatch - Type "n"
Severity: 2
Meaning: The interface type of the specified Line Interface Card (LIC)
installed in the node is different from the interface type configured
in the Line Processor file. As a result, the software did not load
properly and will not operate.
Action: Change either the card or the file.
400.
Link Enabled
Severity: 2
Meaning: The port has been enabled from the On-Line Port Operations Menu.
Action: None.
401.
Link Disabled
Severity: 2
Meaning: The port has been disabled from the On-Line Port Operations Menu.
Action: None.
402.
Link Disconnected
Severity: 2
Meaning: For X.25, this means that the link is disconnected and level 2 cannot
be established.
For SNA TPAD, this means that an XID command frame has been
issued by the TPAD, but either there has been no response or the
received XID data does not match the XID data configured for the
TPAD subscriber. For SNA HPAD, this means that no XID or
SNRM command frame has been received for any link address con-
figured for the HPAD subscriber.
Action: Check the hardware at both ends to make sure the devices are oper-
ational and cables are securely connected. For SNA, also check the
configuration records to make sure they match the HPAD/TPAD.
403.
Link Up
Severity: 2
Meaning: The level 2 link is up.
Action: None.
404.
X.25 Link Failed
Severity: 2
Meaning: The link has failed; some modem controls are not present, and the
physical link is down.
Action: Check the modem and cables for secure connections and proper
operation.
21-9