Cabletron Systems Netlink FRX4000 User Manual page 352

21-8
Meaning: The port statistic
(
T:"n"
Receive Error Ratio is the ratio of frames rejected per second to
frames accepted per second.
Action: If this happens frequently, check the line for noise, and check for
configuration errors on both the port and the connected device.
318.
Rcv Port Usage exceeded T:"n" C:"n"
Severity: 4
Meaning: The port statistic
threshold (
value.) Percent of Receive Port utilization is the ratio of non-flag
characters to total characters being received by the port.
Action: If this happens frequently, you may need to add ports or reroute
some traffic.
319.
Trn Port Usage exceeded T:"n" C:"n"
Severity: 4
Meaning: The port statistic
threshold (
value.) Percent of Transmit Port Utilization is the ratio of non-flag
characters to total characters being received by the port.
Action: If this happens frequently, you may need to add ports or reroute
some traffic.
338.
Receive Yellow Alarm Condition Set
Severity: 2
Meaning: Self-explanatory.
Action: Contact your T1 carrier.
339.
Receive Yellow Alarm Condition Cleared
Severity: 4
Meaning: The condition that caused event 338 has been cleared.
377.
LIC "n" Installed, Not Configured
Severity: 3
Meaning: The specified Line Interface Card (LIC) exists in the node, but has
not been configured in the Line Processor file.
Action: Configure the LIC or remove it from the node.
378.
LIC "n" Configured, Not Installed
Severity: 1
Meaning: The specified Line Interface Card (LIC) has been configured in the
Line Processor file, but does not exist in the node.
Action: Install the LIC or delete its record.
Receive Error Ratio
) that was set by the user. (
% Receive Port Util
) that was set by the user. (
T:"n"
% Transmit Port Util
) that was set by the user. (
T:"n"
has exceeded the threshold
is the current value.) The
C:"n"
(Utilization) has exceeded the
is the current
C:"n"
(Utilization) has exceeded the
is the current
C:"n"
FRX4000/FRX6000 4.0 User Guide, Rev 01