Default Configuration Screen For New Port - Cabletron Systems Netlink FRX4000 User Manual

6-4
X.25 Port Parameters (screen 1 of 6)
* RLP: 0 Port: 5
* I/O: V.35
A Port Type
B Physical Port Interface
C Blocked Port Flag
D Line Speed
E Modulo
F Maximum LAPB Window Size
G N2 Retransmit Count
H T1 Retransmit Period (msec)
I T2 Wait Ack Period (msec)
J T3 Link Alive Period (sec)
K Logical DCE
L Generate Clock
M Rcv Clock (TT) from DTE
Option:
Figure 6-3 Default Configuration Screen for New Port
The entry identifies the LIC containing the port (
I/O
0–3), and will be one of these:
Link State
– The link was shut down by an on-line command, is undergoing re-
Link_disable
IPL, or has not yet been established.
– Some or all modem controls are missing. (This state is passed through
Failed
while a port is becoming enabled.)
– The link was up, but has gone down.
Link_down
– Level 2 cannot be established.
Disconnect
– The necessary level 1 modem signals are present, and the level 2 link is
Linkup
up.
– Some state other than those above has been entered.
NA
To configure the port with the parameter values neccessary for your application, go to
the appropriate chapter:
Frame relay – Chapter 7
X.25 – Chapter 8
SNA – Chapter 9
BSCI – Chapter 10
BSCB – Chapter 11
Async – Chapter 12
If configuring a physical port that will contain logical ports, configure the physical
port as described in the appropriate chapter in the above list, then follow the procedure
under "Configuring Logical X.25
Rmtid=nodexyz
Link State: Link_disable
Database System Memory
X.25 X.25
V.35 V.35
N N
9600 bps 9600 bps
8 8
7 7
5 5
2000 2000
1000 1000
10 10
N N
N N
N N
from Main Menu
[A],[C],[A]
UNIVERSAL
Ports" on page 8-14.
FRX4000/FRX6000 4.0 User Guide, Rev 01
for FRX4000 ports