Tests; Ip Ping Connectivity Test; Ip Ping Connectivity Test Menu - Cabletron Systems Netlink FRX4000 User Manual
Frame relay access products
Hide thumbs
Also See for Netlink FRX4000:
- Maintenance manual (60 pages) ,
- Installation and setup manual (8 pages) ,
- User manual (420 pages)
Table of Contents
Advertisement
Tests
IP Ping Connectivity Test
On-line Operations
The IP Ping function sends packets to an IP host to determine whether the host is
reachable. Press
at the Operations Menu to display the following:
[F]
IP Ping Connectivity Test
A IP Address
B Inter-Packet Time (secs)
Option::
Figure 18-3 IP Ping Connectivity Test Menu
To begin the test:
1. Press
and enter an IP address of the host that will receive (and echo) the pings.
[A]
2. Make any desired change to the
(seconds). This is an interval between transmission of packets.
3. When the parameters are configured the way you want them, press
node will begin sending pings. As each ping is returned from the host, a message
will be displayed, noting the packet size and IP address of the host.
4. To stop sending pings, press
5. Press
again to exit the test menu.
[F3]
Node Name=node_xyz
100.100.100.100
1
, within the range of
Inter-Packet Time
. Test statistics will be displayed.
[F3]
[B],[F]
from Main Menu
1–15
, and the
[F4]
18-15
Advertisement
Table of Contents
