Set Idle Timeouts; Configure The D Channel; Set Phone Numbers And Spids For The Port - Cabletron Systems WPIM-S/T User Manual

3.2.4

Set Idle Timeouts

Set the receive and transmit idle timeouts for backup interfaces using
Network Tools. This command automatically disconnects an idle
switched interface within the parameters:
setidletimeout [IFACENUM] [TRANSMITIDLETIMEOUT]
[RECEIVEIDLETIMEOUT]
IFACENUM
The number of the interface to be configured.
TRANSMITIDLETIMEOUT
The idle time out parameter for the transmit time out.
RECEIVEIDLETIMEOUT
The idle time out parameter for the receive time out.
Example: To set the receive time out to 180 seconds and the transmit side
to 600 seconds for ISDN interface #4, use this command:
setidletimeout 4 180 600
3.2.5 Configure the D Channel
Use the following command in Network Tools to set the switch type:
setswitchtype [WANPORTNUM] [SWITCHTYPE]
WANPORTNUM
If the WPIM-S/T occupies WAN port number one, use 1, if it occupies
port number two, use 2 as the WANPORTNUM.
SWITCHTYPE
Choose between the types of ISDN BRI switches. The choices are NI1,
DMS100, and ATT5 (default is NI1).
3.2.6

Set Phone Numbers and SPIDs for the Port

The following Network Tools command is used to set the phone numbers
and the SPIDs:
setisdnbri [WANPORTNUM] [LDN1][SPID1] [LDN2] [SPID2]
WPIM-S/T User's Guide
Call Back-up Configuration
3-19