Configuring Llc2 Hosts; Llc2 Defaults Configuration Screen - Cabletron Systems Netlink FRX4000 User Manual

Configuring LLC2 Hosts

9-18
Configure Bridge/LLC2 Node Defaults
A Virtual LAN ID
B Bridge Enabled
C Bridge Hello Time
D Bridge Max Age
E Bridge Forward Delay
F Bridge Aging Timer (seconds)
G Bridge Priority
H Max Size Bridge Forwarding Table
I IP Bridging Enabled
J IPX Bridging Enabled
K SRB ID
L Default Ethernet Frame Type
Option:
Figure 9-5 LLC2 Defaults Configuration Screen
Only item A applies to LLC2. Leave the remaining parameters at their
default values.
Each SNA/LLC2 host device that will connect to an FRX4000/6000 running LLC2
must be configured in the database.
To display any LLC2 hosts already configured for this node, press
IP/LLC2/BRIDGE/IPX Default Parameters Menu (or
Menu). This will list the hosts' MAC addresses and identify each LLC2 session as
or
Originated Terminated
in a Terminated session, the host accepts sessions destined for the address.)
A host-to-terminal connection is always initiated by the terminal.
To configure a host, press
eters Menu. When prompted, enter:
:
Host Number 0–128
Any other requested information (if this is a new host), noting
page 9-21).The resulting display will depend on the configured session type:
Figure 9-6 = Originated,
000
N
2
20
15
300
0
65535
N
N
0
Type II
. (In an Originated session, the host initiates LLC2 sessions;
at the Configure IP/LLC2/BRIDGE/IPX Default Param-
[D]
. (Default is .)
0
Figure 9-7 = Terminated.
Node Name=nodexyz
] from Main Menu
[A],[A],[E],[B
at the Configure
[C]
from the Main
[A], [A], [E], [C]
Table 9-4
FRX4000/FRX6000 4.0 User Guide, Rev 01
(on