Cabletron Systems Netlink FRX4000 User Manual page 50

3-12
G Review Model Information
logical connections allowed, and lists the protocols installed, on the
FRX4000/6000.
H Configure Bandwidth Allocation Groups
to 16 groups that assign connection priorities to various types of
traffic.
B Configure RLPs (FRX6000) or
(Chapter 5)
A ReviewRLP (or
any RLPs (see below) already configured in the node. On any node type,
displays installed protocols and identifies installed Line Interface Cards.
B Configure RLP
type of serial expansion card. On an FRX6000, allows specifying the
types of Line Interface Card and protocols installed.
C Display RLP (or
available and used memory on each RLP (or in the similar functionality
in the FRX4000).
C Configure Ports
A Configure RLP Ports
serial port's type, physical interface, and operating parameters.
B Configure LAN Ports
Token Ring) and associated addresses for each LAN interface on an
FRX4000 or FRX6000.
C X.25 Address Translation Templates
and tests templates that are applied to incoming and outgoing call
packets for the purpose of translating selected fields of a packet that may
not otherwise be in a compatible format.
A Review X.25 Address Translation Templates
B Configure X.25 Address Translation Templates
C Test X.25 Address Translation Templates
D Configure Logical Ports
for logical ports residing on physical frame relay ports.
E Configure IP/LLC2/BRIDGE/IPX Interfaces
A Review IP Interfaces
IP interfaces (see below) configured in the FRX4000/6000.
B Configure IP Interfaces
operating parameters for IP interfaces (X.25, frame relay, or LAN).
C Review Bridge Ports
displays information on any bridge or LLC2 interfaces (see below)
configured in the FRX4000/6000.
D Configure
Chapter 15) specifies location, type, and format of any bridge or
LLC2 interfaces.
E Review IPX Interfaces
any IPX interfaces (see below) configured in the FRX4000/6000.
F Configure IPX Interfaces
interfaces. Identifies type (X.25, Ethernet, etc.) and operating
parameters.
F Configure BSC Devices
A Review BSC Device Configuration
BSC Interactive devices (see below) that are configured.
B Configure BSC Devices
ports configured as BSC Interactive.
– displays the maximum number of
Configure Protocols
Protocol ) Configuration
(or Protocol ) – on an FRX4000, allows specifying the
Protocol ) Memory Status
– (Chapter 6 through Chapter 11) specifies each
– (Chapter 5) specifies the type (Ethernet or
– (Chapter 8) specifies operating parameters
– (Chapter 13) displays information on any
– (Chapter 13) specifies addressing and
/ LLC2 Interfaces
Bridge Ports / LLC2 Interfaces
– (Chapter 14) displays information on
– (Chapter 14) identifies any IPX
(Chapter 10)
– identifies devices using FRX4000/6000
FRX4000/FRX6000 4.0 User Guide, Rev 01
– (Chapter 7) defines up
(FRX4000)
– on an FRX6000, identifies
– displays a table showing
– (Chapter 8) displays, specifies,
– (Chapter 9, Chapter 15)
– (Chapter 9,
– displays information on any