Subscriber Addressing; Typical Svc Subscriber Screen - Cabletron Systems Netlink FRX4000 User Manual

Subscriber Addressing

8-22
SVC Subscriber Maintenance
* Subscriber ID
A Subscriber Name
B Routing Algorithm
C Systematic Redirection
D Redirect on Busy
E Redirect on Out of Order
F Connection Priority
G Routing Paths
H Redirection Addresses
Option:
Figure 8-6 Typical SVC Subscriber Screen
If configuring an ID that will be a
Interface (described in
eters after
Subscriber Name
figuring an ID that will be a
Interface, accept the default values for all parameters after
, except
Name
physical X.25 port that will be used as the interface.
Pressing will display routing paths, which link the subscriber with one or more
[G]
ports. Pressing will display the addresses used for call redirection. (These
[H]
addresses are valid only if
first screen.) Parameters for all three screens are described following
Subcriber IDs are the called and calling addresses that are placed in call packets. Each
Subscriber ID record also defines routing for calls to the subscriber. Each subscriber
ID, or address, consists of up to 15 digits, including (if desired) question marks and/
or asterisks used as wildcards. (See "Wildcards in Subscriber Addresses.")
Subscribers using a public data network (PDN) must conform to the format used by
the PDN. For example, CCITT Recommendation X.121 specifies this format: a one-
digit international code, followed by a four-digit Data Network Identification Code
(DNIC), followed by up to 10 digits of Network Terminal Number (NTN).
A private network (that will not communicate with other networks) does not need to
follow the format—any or all of the digits can be used as desired, following the guide-
lines in this chapter.
0100012345
sub1
0, Round Robin
N
N
N
0
Source Subscriber
Chapter 13), accept the default values for all param-
, and do not configure any Routing Path. If con-
Destination Subscriber
, which must be configured as the node and
1st Routing Path
is specified for one or more of items C, D, and E on the
Y
Node Name=nodexyz
from Main Menu
[A],[D],[B]
on an IP (over X.25)
on an IP (over X.25)
Subscriber
Table
FRX4000/FRX6000 4.0 User Guide, Rev 01
8-6.