Rlp Configuration Menu For Frx6000 - Cabletron Systems Netlink FRX4000 User Manual

Configuring Cards and Protocols
RLP Configuration
* RLP: 1 * Status: Installed
* RLP Type: RLP
B Line Interface Card 1: V.35
C Line Interface Card 2: T1-DSX1
F Protocol 1:
G Protocol 2:
H Protocol 3:
I Protocol 4:
J Protocol 5:
K Protocol 6:
L Protocol 7:
M Protocol 8:
N Protocol 9:
Option:
Figure 5-5 RLP Configuration Menu for FRX6000
The line
Configure T1/E1 LIC 1
Card is or
T1
Although nine protocol entries are shown, a 4MB RLP supports a
maximum of five.
To add or remove a protocol, press the letter corresponding to the protocol number.
The protocol in the
Configured
(See Table 5-3.)
After all desired changes have been made, press
the 9W004 as follows:
Rebooting will clear all connections on this device. However, the
device must be rebooted to implement the change.
1. Press .
[F10]
2. When asked:
Reboot the Node?
3. Type
restart [Enter]
* Memory Configuration: 8 Meg
D Configure T1/E1 LIC2
Configured Loaded
X.25 X.25
FRL FRL
Async Async
SDLC SDLC
IP IP
None
None
None
None
[A],[B],[B]
(or ) is displayed if either Line Interface
2
.
E1
column will change to the next valid one.
, press .
[Y]
.
Node Name=nodexyz
from Main Menu
to save the changes, then reboot
[F3]
5-9