Configuring Subscriber IDs
Configuring Async Ports
This operation configures the called and calling addresses that will be used in X.25
call setup if SNA is being transported over a logical X.25 port. To complete the con-
nection, the software must recognize where the call is coming from (calling address)
and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press
Routing Paths Menu (or
To add or change a Subscriber record, press
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on
page
8-22.
SVC Subscriber Maintenance
*
Subscriber ID
A Subscriber Name
B Routing Algorithm
C Systematic Redirection
D Redirect on Busy
E Redirect on Out of Order
F Connection Priority
G Routing Paths
H Redirection Addresses
Option:
Figure 12-3 Typical SVC Subscriber Screen
Pressing
will display routing paths, which link the subscriber with one or more
[G]
ports. Pressing
will display the addresses used for call redirection. (These
[H]
addresses are valid only if
first screen.) Parameters for all three screens are described following
from the Main Menu).
[A], [D], [A]
at the Connections and Routing Paths
[B]
0100012345
sub1
0, Round Robin
N
N
N
0
is specified for one or more of items C, D, and E on the
Y
at the Connections and
[A]
Node Name=nodexyz
[A],[D],[B]
from Main Menu
Table
12-4.
12-15