Remote Frx4000/6000 In Configuration Example 3 - Cabletron Systems Netlink FRX4000 User Manual

Introduction to Database Configuration
Routing Subscriber ID –
all the digits of the Local Subscriber ID (shown later in this list).
Source MAC Address Mask –
the FRX4000/6000 will use to send frames to the AS/400. The last four
digits are for the first 57 Host SAPs (service access points) used to
0000
connect to the host. For subsequent SAPs, the last four digits will be incre-
mented to ,
0001 0002
SAP address in a frame received from the local LAN.)
Host SAP – . (SAP addresses can be
04
Local Subscriber –
Remote Subscriber –
Type – .
LLC2
LLC2 Host 2:
Host MAC Address –
(and is the same as the Host MAC Address configured on Host 0).
Session Type –
Terminated
session to the above MAC address.
Routing Subscriber ID –
all the digits of the Local Subscriber ID (shown later in this list).
Host SAP – . (SAP addresses can be
04
Local Subscriber –
Remote Subscriber –
Type – .
LLC2
Interface 2
Frame Relay
Originated
Figure 3-5 Remote FRX4000/6000 in Configuration Example 3
. This ID must end in an asterisk and contain
99*
. This is the source MAC address
40000000
, etc. (Each Host SAP address must match the Source
04–fe
. This is the Remote Subscriber ID of Host 2.
990*
. This is the Local Subscriber ID of Host 2.
1010*
. This is the AS/400 targeted address
4000000000470
. This host will terminate the frame relay LLC2
. This ID must end in an asterisk and contain
101*
04–fe
. This is the Remote Subscriber ID of Host 2.
990*
. This is the Local Subscriber ID of Host 2.
1010*
Remote FRX
Host 2
Originated
Host 0
Terminated
Interface 0
Token Ring
, hex, in multiples of four.)
, hex, in multiples of four.)
3-5