Configuring Ipx Node Defaults; Ipx Node Defaults Parameters; Ipx Node Defaults Menu - Cabletron Systems Netlink FRX4000 User Manual

Configuring IPX Node Defaults

IPX Node Defaults Parameters

Internal Network
Gap
Router Name
14-2
Press at the Configure IP/LLC2/BRIDGE/IPX Default Parameters Menu (or
[E]
from the Main Menu) to configure default IPX node parameters.
[A], [E], [E]
Configure IPX Node Defaults
A Internal Network
B Gap (55ms intervals)
C Router Name
Option:
Figure 14-1 IPX Node Defaults Menu
Table 14-1 IPX Node Defaults Parameters
Parameter
Internal Network
(55 ms intervals)
Gap
Router Name
identifies the node to the IPX network. If fewer than 8 hex digits are entered, leading
zeros will be added.
is the minimum delay between consecutive RIP and SAP (Service Advertising Pro-
tocol) transmissions. This parameter provides compatibility with older Novell servers.
is simply an identifier for the IPX network. It must be unique within the network.
Node Name=nodexyz
0000001e
1
ipx_router_1
[A],[A],[E],[E]
Valid Values
(8 hex digits)
0–ffffffff
0–100
1–47 characters
FRX4000/FRX6000 4.0 User Guide, Rev 01
[A],
from Main Menu
Default Value
00000000
1
none